Engineering
Engineering, 14.02.2020 18:30, ulilliareinhart2

The Michaelis-Menten equation models the hyperbolic relationship between [S] and the initial reaction rate (vo) for an enzyme catalyzed, single substrate reaction: E + S ES → E + P. The model can be more readily understood when comparing three conditions: [S]<Km. Match each statement with the condition that it describes. Note: "Rate" refers to initial velocity (Vo) where steady state conditions are assumed; [Etotal refers to the total enzyme concentration, and [Efree] refers to the concentration of free enzyme. [S] = Km Not true for any of these conditions almost all active sites are empty Eswl is about equal to Egoud ES] is much higher than [Ereel half of the active sites increasing Eotal will lower Km for most in vivo enzymes this condition rarely occurs are filled with S 0 Incorrect. At leasto approaches a maximum because the rate depends on [ESI, and most of the enzyme is in the ES form.

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 19:30, 10040813
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
image
Engineering, 04.07.2019 18:10, keigleyhannah30
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
image
Engineering, 04.07.2019 18:10, lerasteidl
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
image
Engineering, 04.07.2019 18:10, lillygrl100
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Do you know the correct answer?
The Michaelis-Menten equation models the hyperbolic relationship between [S] and the initial reactio...

Questions in other subjects:

Konu
Computers and Technology, 10.07.2019 08:00
Konu
Mathematics, 10.07.2019 08:00
Konu
History, 10.07.2019 08:00