Engineering, 13.02.2020 18:29, jennamcasey94
A solar flux of 700 W/m2 is incident on a flat-plate solar collector used to heat water. The area of the collector is 3 m2, and 90% of the solar radiation passes through the cover glass and is absorbed by the absorber plate. The remaining 10% is deflected away from the collector. Water flows through thetube passages on the backside of the absorber plate and is heatedfrom an inlet temperature Ti to an outlet temperatureTo . The cover glass, operating at a temperature of30oC, has an emissivity of 0.94 and experiencesradiation exchange with the sky at -10oC. The convectioncoefficient between the cover glass and the ambient air at25oC is 10 W/m2K.
---> How would you perform an overall energy balance on thecollector to get an expression for the rate at which useful heat iscollected per unit area(heat flux).
What would the value of thisbe?
Answers: 3
Other questions on the subject: Engineering
Engineering, 04.07.2019 19:20, natalie2sheffield
Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volurge for a gas is much higher than the average volume for a liquid. d)-there is no difference
Answers: 3
Engineering, 06.07.2019 02:30, josediaz1124
Around steel bar, made from material with a yield stress of 750mpa, is loaded so that it has stresses co locations of maximum normal stress and maximum shear stress. use maximum shear stress and maximum distortion energy theories to calculate the safety factors for initial yielding failures.
Answers: 3
Engineering, 06.07.2019 03:20, mpete1234567890
Asimply supported beam abc of length l has ab of length hl and second moment of area / and bc of length hl and second moment of area i2. determine the strain energy stored in the beam when it is subject to a vertical load f at its midpoint and the consequential central deflection.
Answers: 2
Do you know the correct answer?
A solar flux of 700 W/m2 is incident on a flat-plate solar collector used to heat water. The area of...
Questions in other subjects:
Health, 06.11.2019 07:31
Chemistry, 06.11.2019 07:31
Biology, 06.11.2019 07:31
