Engineering
Engineering, 12.02.2020 05:38, thepantsgirl

A classroom which normally contains 26 people is to be air- conditioned. A person in the classroom typically dissipates heat at a rate of 360 kJ/h. The room is lit with 15 light bulbs which each consume 40 W. A 200 W fan also operates in the room near a door to a computer closet. This fan pulls warm air into the classroom under the door at a rate of 200 kg/h. The room gains 10 kJ in energy (enthalpy) for each kg of warm air which enters. The air comes under the door at 10 m/s and leaves the room with negligible velocity through a large vent 3 m above the floor. Otherwise the room is well sealed. Finally, the room gains 5,000 kJ/h by heat transfer through the walls and windows. Determine the air-conditioner capacity, in kW, that is needed to keep the room at a steady temperature. Are any terms of the energy balance negligible?

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 16:10, Arealbot
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
image
Engineering, 04.07.2019 18:10, niyawilliams23
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
image
Engineering, 04.07.2019 18:10, meganwintergirl
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
image
Engineering, 04.07.2019 18:10, keigleyhannah30
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Do you know the correct answer?
A classroom which normally contains 26 people is to be air- conditioned. A person in the classroom t...

Questions in other subjects: