Engineering, 12.02.2020 05:00, talannajanis

Consider shear panels with uniform thickness of 5 mm made of aluminum alloy with E = 70GPa, and ν = 0.33. Assume simply supported boundary conditions on all edges. One panel is flat while the other panel comprises the same amount of material but is bent into a cylindrical shape.

a) If the panels are loaded with uniform shear along their edges, determine the buckling stress τcr for each of the two panels. Use the charts included on the last page of this assignment for the curved panel case.

b) If the panels are loaded with uniform normal stress along the shorter end, as shown, determine the buckling stress σcr for each of the two panels. Also, for the case of the flat panel, make a sketch illustrating the buckling mode that you expect. [Note: for the curved panel case, look up an appropriate formula/data from "Roark’s Formulas for Stress and Strain.

c) Compare all results and comment.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, volleyballfun24

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

continue

Engineering, 04.07.2019 18:10, chadatkin

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

continue

Engineering, 04.07.2019 18:10, tobyhollingsworth178

Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer

Answers: 2

continue

Engineering, 04.07.2019 18:20, esmemaluma00

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

continue

Do you know the correct answer?

Consider shear panels with uniform thickness of 5 mm made of aluminum alloy with E = 70GPa, and ν =...