Engineering
Engineering, 12.02.2020 04:48, kate460

A pitot tube is mounted in the test section of a low-speed open-circuit subsonic wind tunnel. Air is flowing through the test section at 45 m/s. The air pressure in the test section is approximately that at the University of Denver 83,020 Pa and the Temperature is 298 K (room temperature).
a) Calculate the inlet velocity into the wind tunnel assuming that the contraction ratio of the wind tunnel is 10 to 1.b) Calculate the pressure measured by the pitot tube in the test section (i. e. the stagnation pressure).c) If static ports were used in each section of the wind tunnel (between the converging inlet section and test section), what would be the measured differential pressure?

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 16:10, TheOriginalMeyah
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
image
Engineering, 04.07.2019 18:10, ayoismeisjjjjuan
Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges
Answers: 1
image
Engineering, 04.07.2019 18:20, samantha636
Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg • k, determine for the air the amount of entropy produced, in kj/k
Answers: 2
image
Engineering, 04.07.2019 18:20, rhussein6452
Wiy doeres rere okhn a pump whon working betwon the same pressure range?
Answers: 2
Do you know the correct answer?
A pitot tube is mounted in the test section of a low-speed open-circuit subsonic wind tunnel. Air is...

Questions in other subjects:

Konu
Health, 26.02.2021 01:20