Engineering, 11.02.2020 23:30, hellothere2458

A photovoltaic panel of dimension 2mÃ—4m is installed on the
roof of a home. The panel is irradiated with a solar flux of GS =700W /m2, oriented normal to
the top panel surface. The absorptivity of the panel to the solar
Irradiation is s =0.83, and the efficiency of conversion of the absorbed flux to electrical power
is P /sGsA =0.553âˆ’0.001Tp, where Tp is the panel temperature expressed in Kelvins and A is
the solar panel area. Determine the electric power generated for
a. A still summer day, in which Tsur =T[infinity]=35C, h=100W /m2 â‹…K, and
b. A breezy winter day, for which Tsur =T[infinity]=âˆ’15oC, h=30W /m2 â‹…K. The panel Emissivity is 0.90.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 18:10, yasminothman02

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

continue

Engineering, 04.07.2019 18:10, katelynn73

Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1

Answers: 1

continue

Do you know the correct answer?

A photovoltaic panel of dimension 2mÃ—4m is installed on the
roof of a home. The panel is irra...