Engineering
Engineering, 11.02.2020 20:37, Lscifa

Given the dimensions in the figure above, and the following data:

Water Temperature: 21.6 degrees celsius

(Depth = Depth of the water in each trial and there was seven trials)

(Mass = Mass of each trial needed to equalize the beam)

1. Compare the theoretical force with the measured force. The measured force is obtained by setting the summation of moments about the pivot point equals to zero. However, the calculation involved the assumption that the center of pressure can be calculated from the equation provided below.

2. Also confirm that if depth is less than 100mm, the center of pressure is located h/3 from the bottom of the quadrant(h=depth of water). Explain why the center of pressure is NOT located at a distance h/3 from the bottom of the quadrant for depths greater than 100mm.

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 23:20, abbz13
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
image
Engineering, 04.07.2019 16:10, TheOriginalMeyah
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
image
Engineering, 04.07.2019 18:10, hadellolo8839
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
image
Engineering, 04.07.2019 18:10, ijohnh14
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
Do you know the correct answer?
Given the dimensions in the figure above, and the following data:

Water Temperature: 21....

Questions in other subjects:

Konu
Mathematics, 24.08.2019 00:00
Konu
English, 24.08.2019 00:00