Engineering, 11.02.2020 18:45, christinasmith9633
Three blocks A, B, and C and a grooved block D have dimensions a, b, c, and d as follows: a 1.500 ± 0.001 in h 2.000 ± 0.003 in c = 3.000 ± 0.004 in d = 6.520 ± 0.010 in 7 (a) Determine the mean gap w and its tolerance. (b) Determine the mean size of d that will assure that w 2 0.010 in.
Answers: 2
Engineering, 04.07.2019 18:10, koolgurl2003
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
Engineering, 04.07.2019 18:10, Strick1530
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 19:10, netflixacc0107
What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?
Answers: 2
Three blocks A, B, and C and a grooved block D have dimensions a, b, c, and d as follows: a 1.500 ±...
English, 21.04.2021 18:50
Mathematics, 21.04.2021 18:50
Mathematics, 21.04.2021 18:50