A methanol synthesis loop with a stoichiometric feed of CO and H2 is to be designed for 95% overall conversion of CO. All the methanol formed leaves in the product stream. Not more than 2% of the CO and 0.5% of the H2 emerging form the reactor is to leave in the product stream- the remainder is recycled.
a. Calculated the single pass conversion of CO.
b. Draw a flow chart.

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.