Engineering, 11.02.2020 00:17, leenzazou587

The car travels around the portion of a circular track having a radius of r = 500 ft such that when it is at point A it has a velocity of 4 ft/s , which is increasing at the rate of v˙=(0.004t)ft/s2, where t is in seconds. A-Determine the magnitude of the velocity when it has traveled three-fourths the way around the track. B-Determine the magnitude of the acceleration when it has traveled three-fourths the way around the track.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, caitlynnpatton1208

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

continue

Engineering, 04.07.2019 18:10, wirchakethan23

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

continue

Engineering, 04.07.2019 19:10, jimena15

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

continue

Engineering, 04.07.2019 19:10, pedropaulofpedrosapp

Tom is having a problem with his washing machine. he notices that the machine vibrates violently at a frequency of 1500 rpm due to an unknown rotating unbalance. the machine is mounted on 4 springs each having a stiffness of 10 kn/m. tom wishes to add an undamped vibration absorber attached by a spring under the machine the machine working frequency ranges between 800 rpm to 2000 rpm and its total mass while loaded is assumed to be 80 kg a) what should be the mass of the absorber added to the machine so that the natural frequency falls outside the working range? b) after a first trial of an absorber using a mass of 35 kg, the amplitude of the oscillation was found to be 10 cm. what is the value of the rotating unbalance? c) using me-3.5 kg. m, find the optimal absorber (by minimizing its mass). what would be the amplitude of the oscillation of the absorber?

Answers: 3

continue

Do you know the correct answer?

The car travels around the portion of a circular track having a radius of r = 500 ft such that when...