Engineering
Engineering, 29.01.2020 09:40, mm016281

Calculate all reaction and member forces for the truss below. show all work in your extra sheet of paper, allowing plenty of room for fbds and calculations. make sure all work is legible and neat. be sure to list all formulas, substitutions, and solutions clearly. when you have resolved all forces, draw the fbd for the entire structure at the bottom of your graph paper, showing all applied, reaction, and member forces including type of force.

precision = 0.00 drawing not to scale

-negative 575 lbs on joint b
-roller on joint a
-puller on joint c
-6' from joint a to d
- 3' from d to c
-5' from d to b
- 4 joints
-5 members
- 3 reaction forces
-shaped as a triangle bisected by bd

1.what is the measure of angle bac?
2.what is the measure of angle bcd?
3.what is the magnitude and direction of the reaction force at roller joint a?
4.what is the force on member ab?
5.what is the force on member dc?
6.what is the force on member bc?

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 12:10, Ryantimes2
On a average work day more than work place firs are reorted
Answers: 1
image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 18:10, 19deleonl
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
image
Engineering, 04.07.2019 18:10, keigleyhannah30
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Do you know the correct answer?
Calculate all reaction and member forces for the truss below. show all work in your extra sheet of p...

Questions in other subjects:

Konu
Mathematics, 18.03.2021 06:40
Konu
Mathematics, 18.03.2021 06:40