Engineering, 29.01.2020 05:40, angelina6836

Asteel plate is to be attached to a support with three bolts. the plate is 50 mm wide and 11.2 mm thick and the yield strength of the steel is 250 mpa. the ultimate bearing strength of the bolts is 540 mpa. a factor of safety of 1.67 with respect to yield is required for the plate. a factor of safety of 4.0 with respect to the ultimate bearing strength is required for the bolts. determine the minimum bolt diameter required to develop the full strength of the plate. (note: consider only the gross cross-sectional area of the plate)

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, aliceohern

The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite

Answers: 3

continue

Engineering, 03.07.2019 14:10, bryneosburn

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

continue

Engineering, 03.07.2019 14:10, volleyballfun24

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

continue

Engineering, 04.07.2019 18:10, skpdancer1605

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

continue

Do you know the correct answer?

Asteel plate is to be attached to a support with three bolts. the plate is 50 mm wide and 11.2 mm th...