Engineering, 28.01.2020 07:31, almendares55

For the following environments, indicate which one would be the preferred production system (e. g., job-shop, production line, if necessary provide a one sentence support for your answer. a. manufacturer of clothes: makes many styles (shirts, pants, coats, rain jackets, etc.) and sells to small specialty stores. b. manufacturer of gaskets: makes styles for 4-5 engine blocks: sells to gm and ford (i. e., high volume). c. independent automobile service shop: body work, general service, engine repair, serving many makes of automobiles. d. producer of pharmaceutical drugs: make approximately 50-75 drugs in tablet form: sell to pharmacies nationwide.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, yasminothman02

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, selenamr

Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed. gi) ifn 1, what will happen to the material when transformed material when

Answers: 1

continue

Engineering, 04.07.2019 19:10, rayne40

A)-in the process of engineering design, explain the contribution of material selection. b)- explain the procedure of synthesis as is employed in engineering design. c)- is there any relationship between ergonomics and engineering design? explain. d)- safety consideration in engineering design includes human, product and the enviroment . explain how safety will be incorporated into the design?

Answers: 3

continue

Do you know the correct answer?

For the following environments, indicate which one would be the preferred production system (e. g.,...