Engineering
Engineering, 06.01.2020 21:31, uchechukwueigwe

Jose owns jose’s taqueria and needs to know how to allocate tips for his servers. which of the following best describes how jose should calculate allocated tips
sumar todas las propinas de todos los empleados por la venta de comida y bebidas, menos el 10% por cargo deservicio / add all the employee’s reported tips on food and drink sales, minus 10% service chargesumar todas las propinas de todos los empleados de ventas de comida y bebidas / add all the employee’s reported tips on food and drink salessumar todas las propinas de todos los empleados de venta de comida y bebidas e incluyendo las ventas hechaspara llevar a casa / add all the employee’s reported tips on food and drink sales, including carryout salessumar todas las propinas que recibieron todos los empleados, de venta de comida y bebidas e incluso las ventas de alimentos para llevar, menos el 10% por cargo del servicio / add all the employee’s reported tips on food and drink sales, including carryout sales, minus 10% service charge

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, demarcuswiseman
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
image
Engineering, 04.07.2019 18:10, samanthabutryn
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
image
Engineering, 04.07.2019 18:20, cristykianpour
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
image
Engineering, 04.07.2019 19:20, anggar20
Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 k, 1 bar, with a volumetric flow rate of 0.25 m°/s, and exits at 325 k, 0.95 bar. the flow area is 0.04 m2. assuming the ideal gas model with k = 1.4 for the air, determine (a) the velocity at the inlet and exit, each in m/s, and (c) the rate of heat transfer, in kw flow rate, in kg/s, (b) the mass kg 0.3
Answers: 2
Do you know the correct answer?
Jose owns jose’s taqueria and needs to know how to allocate tips for his servers. which of the follo...

Questions in other subjects: