Engineering
Engineering, 04.01.2020 06:31, peachijmin

Which one of the following activities is not exempt from licensure pursuant to chapter 471, f. s.? a person practicing engineering on property owned by him or her. a full time electrical engineer of progress energy corp. a civil engineer employed full time by the u. s. army corps of engineers. an independent consultant working on the design of an electrical distribution system project for progress energy corp. applicants for licensure with degrees from foreign institutions are required to document "substantial equivalency to abet criteria to the fbpe. they can do this by: providing a transcript from their institution to the board. providing a notarized certification that they have completed the requisite college credit hours set forth in rules 61615-20.007(2)(a) thru (2)(d), f. a.c. getting the evaluation of substantial equivalency from a provider of the service that is approved by the fbpe passing the principles & practice examination in order to verify an applicant's experience, the fbpe: follows guidelines set forth in rule 61615 20.002, f. a.c. relies on information obtained from personal references requires evidence of employment from employers or supervisors who are employed in the engineering profession. • all of the above.

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, EmilySerna
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
image
Engineering, 04.07.2019 18:10, mm016281
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
image
Engineering, 04.07.2019 18:10, koolgurl2003
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
image
Engineering, 04.07.2019 18:10, niicoleassssssf
Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86
Answers: 2
Do you know the correct answer?
Which one of the following activities is not exempt from licensure pursuant to chapter 471, f. s.?...

Questions in other subjects:

Konu
Physics, 14.12.2020 21:20