Engineering
Engineering, 03.01.2020 05:31, holytreesaroy

Astudent team is to design a human-powered submarine for a design competition. the overall length of the prototype submarine is 4.85 m, and its student designers hope that it can travel fully submerged through water at 0.440 m/s. the water is freshwater (a lake) at t = 15 °c. the design team builds a one-fifth scale model to test in their university’s wind tunnel. a shield surrounds the drag balance strut so that the aerodynamic drag of the strut itself does not influence the measured drag. the air in the wind tunnel is at 25°c and at one standard atmosphere pressure. the students measure the aerodynamic drag on their model submarine in the wind tunnel. they are careful to run the wind tunnel at conditions that ensure similarity with the prototype submarine. their measured drag force is 5.75 n. "estimate the drag force" on the prototype submarine at the given conditions.

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, anna22684
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
image
Engineering, 04.07.2019 18:10, chadatkin
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
image
Engineering, 04.07.2019 18:20, 1230bering
Select any two (2) areas of applications of chain-drive. (clo4) a)-permanent lubrication necessary b)-hydraulic forklift truck operation c)-rigging and heavy moving materials d)-relatively high maintenance costs e)-costlier than belt drives
Answers: 2
image
Engineering, 04.07.2019 18:20, ashleyjaslin
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
Do you know the correct answer?
Astudent team is to design a human-powered submarine for a design competition. the overall length of...

Questions in other subjects:

Konu
Computers and Technology, 05.05.2021 21:40
Konu
History, 05.05.2021 21:40
Konu
Physics, 05.05.2021 21:40