Engineering
Engineering, 26.12.2019 22:31, jzoda7318

Consider the following bcnf schema and a portion of a simple corporate database (type
information is not relevant to this question and is omitted):
emp(eid, ename, addr, sal, age, yrs, deptid)
dept(did, dname, floor, budget)
suppose you know that the following queries are the six most common queries in the workload
for this corporation and that all six are roughly equivalent in frequency and importance:
 list the id, name and address of employees in a user-specified age range
 list the id, name and address of employees who work in the department with a userspecified department name
 list the id and address of employees with a user- specified employee name
 list the overall average salary for employees
 list the average salary for employees of each age; that is, for each age in the database,
list the age and the corresponding average salary.
 list all the department information, ordered by department floor numbers.

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, brooklyn674
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
image
Engineering, 04.07.2019 18:10, anna22684
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
image
Engineering, 04.07.2019 18:10, leomessifanboy678
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
image
Engineering, 04.07.2019 18:20, rbgrh9465
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
Do you know the correct answer?
Consider the following bcnf schema and a portion of a simple corporate database (type
informat...

Questions in other subjects:

Konu
Mathematics, 20.02.2021 01:00
Konu
Chemistry, 20.02.2021 01:00