Engineering, 26.12.2019 19:31, waterdrop026

The post is made from 6061-t6 aluminum and has a diameter of 50 mm. it is fixed supported at a and b, and at its center c there is a coiled spring attached to the rigid collar. 0.25 m 0.25 m k = 200 mn/m > b part a if the spring is originally uncompressed, determine the compression in the spring when the load of p = 70 kn is applied to the collar. express your answer to three significant figures and include appropriate units. hår o 2 ? opp = .129 mm submit previous answers request answer x incorrect; try again; 5 attempts remaining

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, makaylashrout77

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

continue

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

Engineering, 04.07.2019 18:10, alyssabailey7545

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

continue

Do you know the correct answer?

The post is made from 6061-t6 aluminum and has a diameter of 50 mm. it is fixed supported at a and b...