Engineering, 21.12.2019 02:31, kutemigos9211

Two kilograms of air within a piston-cylinder assembly execute a carnot power cycle with maximum and minimum temperatures of 750 k and 300 k respectively. the heat transfer to the air during the isothermal expansion os 60 kj. at the end of the isothermal expansion, the pressure is 600 kpa and the volume is 0.4 m^3. assuming the ideal gas model for the air determine: (a) the thermal efficiency(b) the pressure and the volume at the beginning of the isothermal expansion, in kpa and m^3 respectively(c) the work and heat transfer for each of the four processes in kj(d) sketch the cycle on a p-v coordinates

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Engineering, 04.07.2019 18:20, miguel454545

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

continue

Engineering, 04.07.2019 19:10, alex6toes

What are the major differences between injection molding and extrusion?

Answers: 2

continue

Engineering, 06.07.2019 02:30, heavenwagner

A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush

Answers: 3

continue

Do you know the correct answer?

Two kilograms of air within a piston-cylinder assembly execute a carnot power cycle with maximum and...