Engineering
Engineering, 20.12.2019 01:31, duyphan

Here is a series of addresses in hexadecimal: 20(w), 3c(r), 10(r), 16(w), 20(r), 04(w), 28(r), 6(r), 10(w), 17(w)assume a lru replacement algorithm. for the four caches in problem 1, draw each cache as it would appear at the end of the series of references. include the valid bit, dirty bit, and tag. show the contents of the memory block using the byte address range such as m[20-23] for the word with address 22.here is problem 1 for reference. i need some with part d (cache d) in reference to the question above ( i have already solved question 1.1. there are 4 caches with the organization and block size as indicated below. all caches hold 128 words where each word is 4 bytes. assuming a 32-bit address. a. a direct-mapped cache with block size of 16 wordsb. 2-way set-associative cache with block size of 8 words c. 4-way set-associative cache with block size of 4 words d. a fully associative cache with block size of 32 words.

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 18:10, keigleyhannah30
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
image
Engineering, 04.07.2019 18:20, kendrawalraven
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
image
Engineering, 04.07.2019 19:10, shunna33
Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?
Answers: 2
Do you know the correct answer?
Here is a series of addresses in hexadecimal: 20(w), 3c(r), 10(r), 16(w), 20(r), 04(w), 28(r), 6(r),...

Questions in other subjects:

Konu
History, 26.06.2019 17:30
Konu
History, 26.06.2019 17:30
Konu
Mathematics, 26.06.2019 17:30