Engineering, 19.12.2019 06:31, princessksh8

Abearing uses sae 30 oil with a viscosity of 0.1 n·s/m2. the bearing is 30 mm in diameter, and the gap between the shaft and the casing is 2.0 mm. the bearing has a length of 3 cm. the shaft turns at ω = 350 rad/s. assuming that the flow between the shaft and the casing is a couette flow, find the torque required to turn the bearing.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Engineering, 04.07.2019 18:10, chadatkin

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

continue

Engineering, 04.07.2019 18:10, tobyhollingsworth178

Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer

Answers: 2

continue

Engineering, 04.07.2019 18:20, maustin5323

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

continue

Do you know the correct answer?

Abearing uses sae 30 oil with a viscosity of 0.1 n·s/m2. the bearing is 30 mm in diameter, and the g...