Engineering, 19.12.2019 06:31, lakeshia8880

Acompression spring is needed to fit over a 0.5-in diameter rod. to allow for some clearance, the inside diameter of the spring is to be 0.6 in. to ensure a reasonable coil, use a spring index of 10. the spring is to be used in a machine by compressing it from a free length of 5 in through a stroke of 3 in to its solid length. the spring should have squared and ground ends, unpeened, and is to be made from cold-drawn wire.

(a) determine a suitable wire diameter.
(b) determine a suitable total number of coils.
(c) determine the spring constant.
(d) determine the static factor of safety when compressed to solid length.
(e) determine the fatigue factor of safety when repeatedly cycled from free length to solid length, using the gerber fatigue failure criterion with zimmerli data.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, johnthienann58

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

continue

Engineering, 04.07.2019 18:10, Tyrant4life

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

continue

Engineering, 04.07.2019 18:10, chadatkin

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Do you know the correct answer?

Acompression spring is needed to fit over a 0.5-in diameter rod. to allow for some clearance, the in...