Engineering, 19.12.2019 04:31, khikhi1705

Problem 12. the design of the gear and shaft system requires that steel shafts of the same diameter be used for both ab and cd. it is further required that ߬௠௔௫ ൑ 60 mpa, and that the angle ߶஽ through which end d of shaft cd rotates not exceed 1.5°. knowing that g=77.2 gpa, determine the required diameter of the shafts.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, Talos02

Burgers vector is generally parallel to the dislocation line. a)-true b)-false

Answers: 2

continue

Engineering, 04.07.2019 18:10, colin774

The higher the astm grain size number, the finer the gran is. a)-true b)-false

Answers: 2

continue

Engineering, 04.07.2019 18:10, wyattlb97

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

continue

Engineering, 04.07.2019 18:20, rbgrh9465

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

continue

Do you know the correct answer?

Problem 12. the design of the gear and shaft system requires that steel shafts of the same diameter...