Most deformation occurs along plate boundaries because the plates were broken along their boundaries so that is where they are weakest that is where the molten material makes it easy to deform rock the plates are in constant motion and as a result the boundaries are where they interact plates are rigid in their interior but the boundaries are in the asthenosphere.

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.