Engineering, 18.12.2019 21:31, stephaniero6

Select which observations apply to pure bending moments. group of answer choices

a. stress caused by this type of loading is uniform throughout cross-section
b. strain is experienced during loading
c. no shear stress experienced due to this type of loading
d. max stress occurs on boundary of cross-section
e. no stress occurs on boundary of cross-section
f. this type of loading can cause tensile and compressive normal stresses simultaneously
g. stress caused by this type of loading is not uniform throughout cross-section
h. induced stress is inversely related to the area moment of inertia
i. induced shear stress is proportional to torque acting on the cross-section
j. neutral axis in member experiences no strain

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:10, ayoismeisjjjjuan

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

continue

Engineering, 04.07.2019 19:10, nbug2121

Arigid tank contains 10 kg of air at 137 kpa (abs) and 21°c. more air is added to the tank until the pressure and temperature rise to 242 kpa (abs) and 32°c, respectively. determine the amount of air added to the tank. [r-0.287 kj/kg k]

Answers: 3

continue

Do you know the correct answer?

Select which observations apply to pure bending moments. group of answer choices

a. str...