Engineering, 17.12.2019 22:31, aileenzerr9664
In a particular avionics system a radar altimeter is used to determine the height above the ground level (or agl for short). one of the software components uses the radar altimeter height measurement (radar height) to determine if we are within 50', between 50' and 200', between 200' and 500', or above 500' using the following low-level requirement: if (radar height< 50.0) then below50functiono else if (radar height< 200.0) then between50and200functiono else if (radar height< 500.0) then between200and500functiono else above500functiono endif design the test cases necessary to verify this requirement! what is the problem when you base the choice of test cases on the c-code rather than the requirements?
Answers: 1
Engineering, 04.07.2019 18:10, skpdancer1605
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
Engineering, 04.07.2019 18:10, Strick1530
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 19:10, santosbeti90
With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.
Answers: 1
In a particular avionics system a radar altimeter is used to determine the height above the ground l...
Chemistry, 27.07.2019 11:00
Social Studies, 27.07.2019 11:00
English, 27.07.2019 11:00
Mathematics, 27.07.2019 11:00
Mathematics, 27.07.2019 11:00
Mathematics, 27.07.2019 11:00