Engineering, 17.12.2019 21:31, AllanCasey12

An engineer from nebraska is grinding along the work at 0.4 m/s with a wheel speed of 1600 m/min. the depth of cut is 0.05 mm and the wheel diameter is 125 mm. the crossfeed is 6 mm, and the number of active grits are 75 grits/cm2 determine (a) average length per chip (mm). (b) metal removal rate (mm/min), and (c) number of chips formed per unit time during grinding

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:10, lerasteidl

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

continue

Engineering, 04.07.2019 18:10, namira16

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

continue

Engineering, 04.07.2019 18:20, luisgonz5050

Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k

Answers: 3

continue

Do you know the correct answer?

An engineer from nebraska is grinding along the work at 0.4 m/s with a wheel speed of 1600 m/min. th...