Engineering, 17.12.2019 21:31, jakeyywashere

Anew cat6 cable run and keystone jack were installed for a workstation that was moved from the sales department to the shipping department. since the move, the user has been complaining of slow transfer speeds on both internet and local network communications. the technician ran a test and is viewing the following output on the tester. which of the following is the most likely reason for the sluggish network speeds?

a. the cable run exceeds the specifications for ethernet over twisted pair
b. the nic in the workstation is statically set to 10 mbps/half-duplex
c. the network switch port is statically set to 10 mbps/half-duplex
d. the isp is experiencing issues with its service to this customer

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, niicoleassssssf

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

continue

Engineering, 04.07.2019 18:10, wirchakethan23

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

continue

Engineering, 04.07.2019 18:10, mamasbug4285

An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0

Answers: 3

continue

Engineering, 04.07.2019 18:10, QueenLife4869

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

continue

Do you know the correct answer?

Anew cat6 cable run and keystone jack were installed for a workstation that was moved from the sales...