Engineering
Engineering, 14.12.2019 02:31, BIKRAMlawati5544

Aspacer made of sae 1020 hot-rolled steel is in the form of a hollow cylinder with a nominal inside diameter of 3.2500 in and an outside diameter of 4.000 in. it is to be mounted on a solid steel shaft with a heavy force fit. specify the dimensions for the shaft and sleeve, and compute the stresses in the sleeve and shaft after installation at maximum interference. also determine the deformation of the sleeve and shaft. use the basic hole system. the modulus of elasticity of steel, e = 30 × 106 psi and poisson’s ratio, = 0.29.

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, kayabwaller4589
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
image
Engineering, 04.07.2019 18:10, DestyHilBan1183
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
image
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
image
Engineering, 06.07.2019 03:30, carolina1636
The catalogue for a refrigerant 22, four-cylinder, hermetic compressor operating at 29 r/s. a condensing temperature of 40°c and an evaporating temperature of -4°c shows a refrigeration capacity of 115 kw. at this operating point, the motor (its efficiency is 90 percent) draws 34.5 kw. the bore of the cylinders is 87 mm and the piston stroke is 70 mm. the performance data are based on 8°c of sub-cooling of the liquid leaving the condenser. compute (a) the actual volumetric efficiency and (b) the compression efficiency.
Answers: 2
Do you know the correct answer?
Aspacer made of sae 1020 hot-rolled steel is in the form of a hollow cylinder with a nominal inside...

Questions in other subjects:

Konu
Mathematics, 14.07.2019 15:00