Consider a cache with 2 word blocks, which is byte addressable.
a) if this cache holds 6...
Engineering, 14.12.2019 02:31, anthonywdjr6691
Consider a cache with 2 word blocks, which is byte addressable.
a) if this cache holds 64 kb of data, how many index bits does it need and why?
b) what is the total cache size that holds these data considering that it uses 3-bit word offset and 1-bit block offset (do not forget about the valid bits it uses);
c) we decide to increase the cache so it can hold to 128 kb of data. each block this time has 8 words. how many index bits does this new cache have and why?
d) what is the total size of this new cache, if it uses 3-bit word offset and a number of block offset bits needed by the mux to determine which word is needed by the pipeline?
e) draw the cache in question d.
Answers: 3
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, tjeffers90028
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 04.07.2019 18:10, katelynn73
Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1
Answers: 1
Engineering, 04.07.2019 19:20, horsedoggal1234
Consider airflow over a flat plate of length l = 1.5 m under conditions for which transition occurs at le = 0.9 m based on the critical reynolds number, re, e = 5 x 10. evaluating the thermophysical properties of air at 400 k, determine the air velocity. (hint: use the tables to find the properties of air)
Answers: 3
Engineering, 06.07.2019 03:20, shelbellingswo
Aload of 10kn is to be suddenly applied to the free end of a vertical rod of length 500 mm, the upper end being rigidly fixed. 190 mechanical science what should the diameter of the rod be if the maximum stress in the rod is not to exceed 100 mpa? the tensile modulus of the rod is 205 gpa.
Answers: 2
Do you know the correct answer?
Questions in other subjects:
Mathematics, 01.03.2021 22:50
Chemistry, 01.03.2021 22:50
Mathematics, 01.03.2021 22:50
History, 01.03.2021 22:50
