Engineering, 13.12.2019 06:31, 21hendlill

1)a rectangular clarifier with a length to width ratio of 3: 1 receives a flow of 850 m3/d. the clarifier’s depth is 4 m and the detention time of the water in the clarifier is2.4 hours. what are the surface overflow rate and horizontal flow through velocity if the flow is distributed uniformly across the cross section of the tank? 2)you are asked to aid in the design of a settling chamber that will be used to remove silica particles from an air stream (temperature = 25degrees c). if the particles have a diameter of 10 x10-6 m and a specific gravity of 2.6, calculate the settling velocity. if the chamber receives a flowrate10 m3/s design a (specify length width and height) chamber that will effectively remove these particles from the airstream.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, volleyballfun24

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

continue

Engineering, 04.07.2019 18:10, DestyHilBan1183

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, ijohnh14

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

continue

Do you know the correct answer?

1)a rectangular clarifier with a length to width ratio of 3: 1 receives a flow of 850 m3/d. the clar...