Engineering, 12.12.2019 23:31, holman9308

Using a forked rod, a 0.2-kg smooth peg p is forced to move along the vertical slotted path r = (0.5 θ) m, where θ is in radians. the angular position of the arm is θ = (π/8t^2) rad where t is in seconds. the peg is in contact with only one edge of the rod and slot at any instant.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, margaret1758

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

continue

Engineering, 04.07.2019 18:10, ayoismeisjjjjuan

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

continue

Engineering, 04.07.2019 18:20, rbgrh9465

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

continue

Engineering, 04.07.2019 19:10, juneham

Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.

Answers: 2

continue

Do you know the correct answer?

Using a forked rod, a 0.2-kg smooth peg p is forced to move along the vertical slotted path r = (0.5...