Engineering
Engineering, 12.12.2019 23:31, nickname9154

Vito wants to minimize the total distance to all of them and has blackmailed you to write a program that solves his problem. inputthe input consists of several test cases. the first line contains the number of test cases. for each test case you will be given the integer number of relatives r ( 0 < r < 500) and the street numbers (also integers) s1, s2, si, sr where they live ( 0 < si < 3 ). note that several relatives could live in the same street number. outputfor each test case your program must write the minimal sum of distances from the optimal vito's house to each one of his relatives. the distance between two street numbers si and sj is dij= |si-sj|.sample input22 2 43 2 4 6sample output24

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, bryneosburn
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
image
Engineering, 04.07.2019 18:10, DestyHilBan1183
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
image
Engineering, 04.07.2019 18:10, alyssabailey7545
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
image
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Do you know the correct answer?
Vito wants to minimize the total distance to all of them and has blackmailed you to write a program...

Questions in other subjects:

Konu
Advanced Placement (AP), 04.11.2021 14:00
Konu
Mathematics, 04.11.2021 14:00
Konu
Mathematics, 04.11.2021 14:00