Engineering, 12.12.2019 04:31, succ29

An adiabatic turbine (but not isentropic) has steam enter at a pressure of 200 psia, a temperature of 500 f and a velocity of 40 ft/s. the steam leaves at 20 psia and a temperature of 300 f an da velocity of 20 ft/s. the turbine is providing 100 horespower of work. answer the questions below but be careful to answer the correct question.

1. what is the actual mass flow in lbm/s through this turbine to three significant digits?
2. what is the maximum physically possible the turbine could supple in horsepower (hp) to three significant digits?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, theamandawhite

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

continue

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:10, colin774

The higher the astm grain size number, the finer the gran is. a)-true b)-false

Answers: 2

continue

Engineering, 04.07.2019 18:20, dlr1628

Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?

Answers: 2

continue

Do you know the correct answer?

An adiabatic turbine (but not isentropic) has steam enter at a pressure of 200 psia, a temperature o...