Engineering
Engineering, 11.12.2019 03:31, campbellkruger

Aperson is planning a bungee jump from a 40 meter high bridge. under the bridge is a river with crocodiles, so the person does not want to be submerged into the water. the rubber rope fastened to the ankles has a spring constant of 3,600 n/m per meter length. thus one meter length of rope will have a spring constant of 3,600 n/m, two meters of rope will have a spring constant of 1,800 n/m, three meters of rope will have a spring constant of 1,200 n/m and so forth. the distance from the ankles to the top of the head is 175 cm, and the person has a mass of 80 kg. calculate: a. b. c. how long the rope should be [m] how much deflection the rope experiences [m] how much impact force the bungee jumper experiences [n]

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 18:10, sarahgrindstaff123
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
image
Engineering, 04.07.2019 18:10, leomessifanboy678
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
image
Engineering, 04.07.2019 18:20, maustin5323
Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]
Answers: 1
Do you know the correct answer?
Aperson is planning a bungee jump from a 40 meter high bridge. under the bridge is a river with croc...

Questions in other subjects:

Konu
Mathematics, 12.03.2021 08:10
Konu
Mathematics, 12.03.2021 08:10