Engineering
Engineering, 10.12.2019 03:31, milkshakegrande101

After typing the command umask 731 the permissions on all subsequently created files and directories will be affected. in this case, what will the permissions on all new files be?

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, EmilySerna
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
image
Engineering, 04.07.2019 18:10, tjeffers90028
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
image
Engineering, 04.07.2019 18:10, abdirahmansoloman
Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?
Answers: 1
image
Engineering, 04.07.2019 19:10, jrcspiderman2003
Asteel wire of 2 mm diameter is fixed between two points located 2 m apart. the tensile force in the wire is 250n, if its density of steel is given by 7830 kg/m3 the fundamental frequency of vibration hz? ?
Answers: 3
Do you know the correct answer?
After typing the command umask 731 the permissions on all subsequently created files and directories...

Questions in other subjects:

Konu
Mathematics, 11.09.2020 14:01
Konu
English, 11.09.2020 14:01
Konu
Biology, 11.09.2020 14:01
Konu
Mathematics, 11.09.2020 14:01
Konu
Mathematics, 11.09.2020 14:01
Konu
Mathematics, 11.09.2020 14:01
Konu
Biology, 11.09.2020 14:01
Konu
Mathematics, 11.09.2020 14:01
Konu
Social Studies, 11.09.2020 14:01
Konu
Mathematics, 11.09.2020 14:01