Engineering
Engineering, 07.12.2019 02:31, taekookie01

Consider a lossless dc series fed motor. (i. e. one where there is no resistance in either the field or the armature windings.) if this motor is operating at a constant speed under load, and the load suddenly changes so that the load torque drops by a factor of 3, by what factor will the speed of the motor change ? support your conclusion with analysis based on the theory of this kind of motor

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 19:20, rida10309
At steady state, air at 200 kpa, 325 k, and mass flow rate of 0.5 kg/s enters an insulated duct having differing inlet and exit cross-sectional areas. the inlet cross-sectional area is 6 cm2. at the duct exit, the pressure of the air is 100 kpa and the velocity is 250 m/s. neglecting potential energy effects and modeling air as an 1.008 kj/kg k, determine ideal gas with constant cp = (a) the velocity of the air at the inlet, in m/s. (b) the temperature of the air at the exit, in k. (c) the exit cross-sectional area, in cm2
Answers: 2
image
Engineering, 06.07.2019 04:10, nickmoose04
Aheat pump with refrigerant-134a as the working fluid is used to keep a space at 25°c by absorbing heat from geothermal water that enters the evaporator at 500c at a rate of 0.065 kg/s and leaves at 40°c. the refrigerant enters the evaporator at 20°c with a quality of 23 percent and leaves at the inlet pressure as saturated vapor. the refrigerant loses 300 w of heat to the surroundings as it flows through the compressor and the refrigerant leaves the compressor at 1.4 mpa at the same entropy as the inlet. determine: (a) the degrees of subcooling of the refrigerant in the condenser, b)-the mass flow rate of the refrigerant . (c) the heating load and the cop of the pump, and d)-the theoretical minimum power input to the compressor for the same heating load.
Answers: 3
image
Engineering, 06.07.2019 04:20, robertgib76
Derive the 2-d finite difference equation for a uniform grid for a node: a) at a plane surface with a uniform heat flux b) at an internal corner with convection
Answers: 1
image
Engineering, 06.07.2019 04:30, samvgesite
What is the principle of operation of a mechanical dynamometer?
Answers: 1
Do you know the correct answer?
Consider a lossless dc series fed motor. (i. e. one where there is no resistance in either the field...

Questions in other subjects:

Konu
Mathematics, 15.08.2021 21:50
Konu
Mathematics, 15.08.2021 21:50
Konu
Business, 15.08.2021 21:50