Engineering, 05.12.2019 20:31, mem8163

1. define common mode and difference mode gain, and cmrr. how does one determine these quantities via in-circuit measurements? 2. review the use and setup of an instrumentation amplifier, op amp offset voltage nulling, a first order passive hp filter and a first order active lp filter. explain why an instrumentation amplifier is designed with two stages (i. e., what does each stage do? ) and also the purpose of offset nulling in an op amp. 3. design circuit blocks as follows using common resistors and capacitors (i. e., 10 pf caps, 10 k ohm resistors, etc.): passive hp filter: break frequency of about .5 hz (~3 radians/sec) active lp filter: break frequency of about 100 hz (~630 radians/sec) instrumentation amplifier with input stage amplification of > 50 and difference stage amplification of greater than > 20.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, theamandawhite

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

continue

Engineering, 04.07.2019 18:10, skpdancer1605

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

continue

Engineering, 04.07.2019 18:10, jojoangelique13

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

continue

Engineering, 04.07.2019 18:10, krystabrewer3

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

continue

Do you know the correct answer?

1. define common mode and difference mode gain, and cmrr. how does one determine these quantities vi...