Engineering, 05.12.2019 04:31, aileen57

Apipe with closed ends has a wall thickness of 10 mm and an inner diameter of 0.60 m. it filled with a gas at 20 mpa pressure and subjected to a torque about its long axis of 1200 kn·m. a. determine the three principal normal stresses and the maximum shear stress. recall from basic mechanics that: = t 2 b. if the pipe is constructed of oil-quenched and tempered 4340 steel with a yield strength of 1620 mpa, what is the safety factor against yielding using the tresca maximum shear stress criterion? c. prior to loading, an inside crack is discovered through 25% of the thickness of the sample. with this crack, what is the safety factor against fracture if the plane strain fracture toughness is 87.4 mpa√m?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, alyssabailey7545

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

continue

Engineering, 04.07.2019 19:10, batmanmarie2004

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

continue

Engineering, 06.07.2019 03:10, tyheath42

Steel balls 12 mm in diameter are annealed by heating to 1150 k and then slowly cooled to 400 k in an air att 325 k and h -20 w/m2 k. assume the properties of the steel to be k- 40 w/m k, p 7800 kg/m3, and cp 600 j/kg k. a. determine whether lumped system method can be used to analyze this problem and if so why" b. determine the time required for the cooling process. c. determine the total amount of heat lost from each ball to the ambient air

Answers: 1

continue

Do you know the correct answer?

Apipe with closed ends has a wall thickness of 10 mm and an inner diameter of 0.60 m. it filled with...