Engineering
Engineering, 03.12.2019 22:31, Yeetious

Finn likes it when her days are unpredictable and filled with problems to solve. she thrives on solving puzzles and then testing out the different solutions in search of the ""right fit."" how would you describe finn’s personality?

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:20, rocio5649
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
image
Engineering, 04.07.2019 19:20, diawia
Air at a pressure of 1atm and a temperature of 40 c is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 120 c. the plate has a length of 0.40m (in the flow direction) and a width of 0.15m. the reynolds number based on the plate length is 50, 000. what is the rate of heat transfer from the plate to the air? if the free stream velocity of the air is doubled and the pressure is increased to 10 atm what is the rate of heat transfer?
Answers: 2
image
Engineering, 06.07.2019 04:10, makenziemartinez
Aheat pump using refrigerant-134a heats a house by using underground water at 8°c as the heat source. the house is losing heat at a rate of 60,000 kj/h. the refrigerant enters the compressor at 280 kpa and 0°c, and it leaves at 1 mpa and 60°c. the refrigerant exits the condenser at 30°c. determine: (a) the power input to the heat pump, (b) the rate of heat absorption from the water, and (c) the increase in electric power input if an electric resistance heater is used instead of a heat pump
Answers: 2
image
Engineering, 06.07.2019 06:10, rahrah14
Abritle material made of astm grade 30 cast iron has ultimate strength in tension of 31 kpsi and altimate strength in compression of 109 kpsi and undergoes the following plane of stress te 20 lepst and ry10 kpsi (cw). a) using the 3d mohr's circle, find all three principal normal stresses. b) using the brittle-coulomb-mohr theory and modified-mohr theory. ind the factors of safety for the given plane of stress state.
Answers: 1
Do you know the correct answer?
Finn likes it when her days are unpredictable and filled with problems to solve. she thrives on solv...

Questions in other subjects: