Engineering
Engineering, 03.12.2019 21:31, stdntlogin3206

Technician a says that carbon monoxide (co) and hydrocarbon (hc)
levels should increase if the air injection reactor (air) hoses are pinched off.
technician b says that a defective drive belt may cause air system
problems. who is correct?
a. technician a
b. both technicians a and b
c. technician b
d. neither technician a nor b
15. which of these items will least likely increase pressure in the
evaporative emission control system?
a. returned fuel from the fuel-injection system
b. inlet fuel to the fuel pump
c. fuel temperature
d. volatility of the fuel
12. as the efficiency of the catalytic converter drops through deterioration,
the switching rate of the rear o2 sensor signal will start to look like the front
o2 sensor signal. when the rear o2 sensor signal reaches approximately 75
percent of the front o2 sensor, which of the following is the result?
a. the catalyst beads in the converter should be changed.
b. the diagnostic trouble code is stored with the mil on.
c. the catalytic converter should be replaced.
d. a one-trip flag is set with a code stored, but the mil isn't activated.
7. which of these engine concerns may be caused by a stuck-open
exhaust gas recirculation (egr) valve?
a. ping (spark knock or detonation)
b. engine missing at highway speed
c. excessive nox exhaust emissions
d. rough idle/stalling

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, brooklyn674
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
image
Engineering, 04.07.2019 18:10, ashleybaber4966
If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79
Answers: 1
image
Engineering, 04.07.2019 18:10, yasminothman02
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
image
Engineering, 04.07.2019 18:10, xboxdude06
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Do you know the correct answer?
Technician a says that carbon monoxide (co) and hydrocarbon (hc)
levels should increase if the...

Questions in other subjects:

Konu
Chemistry, 29.11.2020 14:10