Engineering, 02.12.2019 22:31, amarionlucas06
Arotating cylinder placed in a two dimensional incompressible uniform flow has two stagnation points on its lower section. when the angular velocity of the cylinder is increased to 3/2 times its initial value, the angle between the stagnation points decreases with an amount of π/3. find the initial locations of the two stagnation points.
Answers: 2
Engineering, 04.07.2019 18:10, anna22684
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10, ijohnh14
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
Arotating cylinder placed in a two dimensional incompressible uniform flow has two stagnation points...
Mathematics, 18.07.2019 07:00
Mathematics, 18.07.2019 07:00
Social Studies, 18.07.2019 07:00
History, 18.07.2019 07:00
History, 18.07.2019 07:00