Engineering, 02.12.2019 20:31, shakira11harvey6

Agundrilling operation is used to drill a 9/64-in diameter hole to a certain depth. it takes 4.5 minutes to perform the drilling operation using high pressure fluid delivery of coolant to the drill point. the current spindle speed = 4000 rev/min, and feed = 0.0017 in/rev. in order to improve the

surface finish in the hole, it has been decided to increase the speed by 20% and decrease the feed

by 25%. how long will it take to perform the operation at the new cutting conditions?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, bryneosburn

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

continue

Engineering, 04.07.2019 18:10, ashleybaber4966

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

continue

Engineering, 04.07.2019 18:10, alyssabailey7545

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Do you know the correct answer?

Agundrilling operation is used to drill a 9/64-in diameter hole to a certain depth. it takes 4.5 min...