Engineering, 02.12.2019 18:31, armstrongstang420

Parts arrive at a two-machine system according to an exponential interarrival distribution with mean 20 minutes; the fi rst arrival is at time 0. upon arrival, the parts are sent to machine 1 and processed. the processing-time distribution is tria(4.5, 9.3, 11) minutes. the parts are then processed at machine 2 with a processing-time distribution as tria(16.4, 19.1, 20.8) minutes. the parts from machine 2 are directed back to machine 1 to be processed a second time (same processing-time distribution as the fi rst visit but an independent draw from it). the completed parts then exit the system. run the simulation for a single replication of 20,000 minutes to observe the average number in the machine queues and the average part cycle time.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, oshawn108

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg. k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m. k

Answers: 2

continue

Engineering, 04.07.2019 19:10, juneham

Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.

Answers: 2

continue

Engineering, 06.07.2019 02:30, emiller6462

Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers

Answers: 3

continue

Engineering, 06.07.2019 03:10, zah16

List and describe the parts of boxford cnc milling machine with pictures?

Answers: 2

continue

Do you know the correct answer?

Parts arrive at a two-machine system according to an exponential interarrival distribution with mean...