Engineering, 28.11.2019 20:31, dimondqueen511

Apump creates a water pressure of 1 mpa in the supply line to a 65-mm-diameter, 300-m-long hose with a roughness height of 0.5 mm, the end of the hose is at an elevation 2.8 m higher than the beginning of the hose. the objective is to place a nozzle at the end of the hose that will create a jet of water that rises 15 mn into the air part a if the local head loss coefficient of the nozzle is 0.04, what nozzle diameter should be used? assume water at 20 c

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, brooklyn674

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

continue

Engineering, 04.07.2019 16:10, TheOriginalMeyah

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

continue

Engineering, 04.07.2019 19:10, kelseiroll9759

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

continue

Engineering, 04.07.2019 19:20, zoebtharpe

Heat transfer by is the fastest mode of heat transfer that requires no intervening medium. a)-conduction b)-convection c)-radiation d)-conduction and convection

Answers: 1

continue

Do you know the correct answer?

Apump creates a water pressure of 1 mpa in the supply line to a 65-mm-diameter, 300-m-long hose with...