Engineering, 27.11.2019 23:31, grey00

Agas-turbine cycle with two stages of compression (intercooling) and two stages of expansion (reheat) is considered. the inlet air to the first compression stage is at 300 k. the compression efficiency in each stage is 0.8 and expansion efficiency in each stage is 0.85. the compression and expansion ratio in each stage is 3. the air is cooled to its initial temperature after the first compression and is reheated to the maximum temperature after the first expansion. the air is at the temperature of 1200 k leaving the combustor. consider one case without a regenerator and a case with a regenerator with effectiveness of 0.75.a) show the t-s diagram of the cycle. b) determine the back work ratio with and without generator. c) determine the thermal efficiency of the cycle with and without the generator.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, mm016281

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

continue

Engineering, 04.07.2019 18:10, Candi9697

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

continue

Engineering, 04.07.2019 18:10, oshawn108

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg. k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m. k

Answers: 2

continue

Engineering, 04.07.2019 18:10, juansoto227711

Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery

Answers: 2

continue

Do you know the correct answer?

Agas-turbine cycle with two stages of compression (intercooling) and two stages of expansion (reheat...