Engineering, 26.11.2019 20:31, Dmgirl123

To use the method of superposition to calculate a beam defection and slope.
for beams with small deflections, the assumptions for using the method of superposition apply: the deflections and slopes are linearly related to the load, and the deflections do not significantly change the original geometry of the beam.

the deflections and slopes for beams subjected to multiple loads can then be found using linear combinations of known results for individual loads.

use the two loadings below and the principle of superposition to answer the following questions.

determine the load combination a beam is subjected to the loading shown where w_a = 2 kn/m and w_b = 2.8 kn/m .

describe the loading as a linear combination of the loads in the above table.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, brooklyn674

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

continue

Engineering, 04.07.2019 18:10, heidiburgos1own6c0

Fluids at rest possess no flow energy. a)- true b)- false

Answers: 3

continue

Engineering, 04.07.2019 18:10, skpdancer1605

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

continue

Engineering, 04.07.2019 18:20, moneywaydaedae

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

continue

Do you know the correct answer?

To use the method of superposition to calculate a beam defection and slope.
for beams with sm...