Engineering
Engineering, 26.11.2019 06:31, holamigosss

Acenter-cracked plate is loaded in tension and has dimensions of b = 40 mm, t = 5 mm, and large h, and it contains an initial crack of length 2ai = 8 mm. a zero-to-maximum cyclic load of 80 kn is applied, and the material has σy= 320 mpa, kic= 40 mpa√m.

(a)what is the crack length for plastic yielding, ay?

(b)what is the crack length for brittle fracture, ac?

(c) will the plate fail by

i. plastic yielding before fatigue crack growth,

ii. plastic yielding after fatigue crack growth,

iii. brittle fracture before fatigue crack growth, or

iv. brittle fracture after fatigue crack growth?

briefly explain why.

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, breannaasmith1122
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
image
Engineering, 03.07.2019 15:10, theamandawhite
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
image
Engineering, 03.07.2019 19:30, 10040813
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
image
Engineering, 04.07.2019 16:10, Arealbot
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Do you know the correct answer?
Acenter-cracked plate is loaded in tension and has dimensions of b = 40 mm, t = 5 mm, and large h, a...

Questions in other subjects: