Engineering, 25.11.2019 19:31, santoskasey
You are hired as a consultant software architect to design the class responsibility collaboration (crc) cards for this system. from the courses and classes records system requirements definitions document, identify the classes of the system. using the provided module three discussion solution submission template, document each class showing its responsibilities, collaborations, attributes, and relationships.
Answers: 1
Engineering, 03.07.2019 15:10, brooklyn674
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10, xboxdude06
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Engineering, 04.07.2019 18:20, aly95
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
You are hired as a consultant software architect to design the class responsibility collaboration (c...
Mathematics, 28.07.2021 19:20
Social Studies, 28.07.2021 19:20
Mathematics, 28.07.2021 19:20
Health, 28.07.2021 19:20
Mathematics, 28.07.2021 19:20