Engineering, 22.11.2019 06:31, Hfruit

Glycerin is being heated by flowing between two very thin parallel 1-m-wide and 10-m-long plates with 12.5-mm spacing. the glycerin enters the parallel plates with a temperature 20°c and a mass flow rate of 0.7 kg/s . the outer surface of the parallel plates is subjected to hydrogen gas (an ideal gas at 1 atm) flow width-wise in parallel over the upper and lower surfaces of the two plates. the free-stream hydrogen gas has a velocity of 3 m/s and a temperature of 150°c. determine the outlet mean temperature of the glycerin, the surface temperature of the parallel plates, and the total rate of heat transfer. evaluate the properties for glycerin at 30°c and the properties of h2 gas at 100°c. are these good assumptions?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, niyawilliams23

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

continue

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:20, samantha636

Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg • k, determine for the air the amount of entropy produced, in kj/k

Answers: 2

continue

Engineering, 04.07.2019 19:10, santosbeti90

With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.

Answers: 1

continue

Do you know the correct answer?

Glycerin is being heated by flowing between two very thin parallel 1-m-wide and 10-m-long plates wit...